TSC MB240 Series Service Manual

18
3.9 Replacing the Internal Full Rewinder Kit (Option)
1. Refer to Remove the Electronics Cover to remove the electronics cover.
2. Install the internal full rewinder module on the positioning holes and fix the module by fasten 3 screws (fastened by 10.5 kg±
15% kg-cm) as indicated.
3. Install the internal full rewinder module cable on the main board cable socket as indicated.
Screws
Positioning holes

TSC MB240 Series Specifications

General

Print Method	Thermal Transfer/Direct Thermal
Resolution	203 dpi
Processor	32-bit RISC CPU
Operating Humidity	25-85% non-condensing
Connectivity	USB 2.0, RS-232
Media Sensor	Reflective, Transmissive
Media Type	Continuous, Die-cut, Black mark, Fan-fold, Notched
Media Width	25.4 mm
Media Thickness	0.06 mm
Media Core Diameter	25.4 mm (1")
Media Max Roll Diameter	127 mm (5")
Ribbon Width	110 mm
Ribbon Length	300 m
Ribbon Core Diameter	25.4 mm (1 inch)
Power	100 - 240 VAC, 50/60 Hz
Maximum Print Length	9999 mm
Label Width	25.4 mm
Label Thickness	0.06 mm
Power Supply	100-240V AC, 50-60Hz
Operating Temperature	5°C - 40°C
Storage Temperature	-20°C - 60°C
Certifications	CE