TSC MB240 Series - 3.6 Replacing the Label Supply Spindle

14
3.6 Replacing the Label Supply Spindle
1. Refer to Remove the Electronics Cover to remove the electronics cover.
2. Remove the 2 screws (fastened by 7.5 kg±15% kg-cm) and 2 hexagon screws (fastened by 7.5 kg±15% kg-cm) on interface
board; Remove the 2 screws on slot-in Wi-Fi/ GPIO interface board (if module installed).
3. Remove 4 screws (fastened by 7.5 kg±15% kg-cm) and all connectors on the main board.
Screws of Wi-Fi
or GPIO interface
Screws
Screws of
main board
Hexagn
screws