Wrinkle happens from label lower right to upper left direction
◼ Make sure the Print head Pressure Adjustment Knob is in correct position for the current media. Ex: 1~2”, 3~4”
◼ Turn the screw clockwise per level and print to see if the winkle has g1.
◼ If the ribbon tension adjustment knob has positioned on the level of innermost side but doesn’t improve the ribbon wrinkle,
please switch the print head pressure at 1 level and print the label again to check if the wrinkle is g1.
◼ If the wrinkle can’t be avoided, please contact the Customer Service Department of your purchased reseller or distributor for
service.
To Next Page
Loading...
