TSC MH341 Series - Power-On Utilities

15
2.3.3 Power-on Utilities
MH241/ 241T/ 241P Series have the power-on utilities for user to set sensor calibration, self-test, and
factory default functions. Please refer to the template below to setup the settings.
Please follow the steps below for different power-on utilities.
1. Turn off the printer power switch.
2. Hold on the right side of the select key ( ) then turn on the power switch.
3. Release the button when LCD monitor indicates with different functions.
4. Printer will setup the functions showing on the LCD monitor accordingly.
The sequences of the settings:
Power on utilities
The LED color will be changed as following pattern:
LED color
Functions
(showing on LCD monitor)
Amber
Red
(5 blinks)
Amber
(5 blinks)
Green
(5 blinks)
Green/Amber
(5 blinks)
Red/Amber
(5 blinks)
Solid green
1. Sensor Calibration (Gap / black mark
sensor)
Release
2. Self-test and enter dump mode
Release
3. Factory Default
Release
4. Bline Calibration
Release
5. Gap Calibration
Release
6. READY (Skip AUTO.BAS)
Release