TA210/ TA310/ TA200/ TA300
Bar Code Printer Service Manual
22
3.10 Peel-off Module Installation (Option)
1. Please refer to the section 3.6 to
remove the platen roller
assembly.
2. Unscrew one screw to remove
the connector cover.
3. Plug in the peel-off module
harness connector to the 5-pin
red socket on the main board.
4. Fasten back the connector
cover. Install the peel-off panel
by putting the both sides of tabs
into the holes on front inner
printer.
To Next Page
Loading...
