3.4 Loading the Label Stock
1. Insert a 1” label spindle into a paper roll ( * If your paper core is 1 inch, remove the 1.5” core adapter from the fixed tab. If label
width is 4 inch wide, two fixing tabs are not required.)
2. Pull the lever to open the cover.
3. Place a roll of paper onto the center of the paper roll mount.
4. Feed the paper>Adjust the paper guides.
5. Lift the cover to the ultimate open angle then use both hands to close the cover gently. Close the printer top cover slowly and
make sure the cover latches securely.
Printing Side
1.5” Core
To Next Page
Loading...
