3.2 Instructions to Top Cover Operation
Please take care when opening or closing the printer’s top cover by carefully following these instructions.
When Opening:
1. When facing the front of the printer pull the cover release levers on both sides of printer towards you.
2. Lift up the top gradually.
There are two stop positions for the top cover. Position 1 and 2 are indicated on the label below.
Note: To hold the cover open at position 1, you must lift the cover higher than the stopping point at position 1 and
gently lower the cover to stop position 1. DO NOT free fall the top cover!
3. Fully open the top cover and gently lower it to stop position 2.
Top cover support is fixed at position 2
To Next Page
Loading...
