3.1.1-1.7 Reference X & Reference Y:
This option is used to set the origin of printer coordinate system horizontally and
vertically. Press the button to move the cursor from left digit to right digit,
and press the button to set the value from “0” to “9”. Press the
button to set the value into printer. Press key to cancel the setting and
return to the previous menu. The default value is 000.
Note: If printing from enclosed software/driver, the software/driver will send
out the REFERENCE command, which will overwrite the setting set
from the front panel.
3.1.1-1.8 Code Page:
Use this option to set the code page of international character set. For more
information about code page, please to refer the programming manual.
When enter the code page list, the code page in the right side of “>” icon is the
printer current setting.
Press the and to select the code page, and press the
button to enable the setting. Press key to cancel the setting and return
to the previous menu.
Note: If printing from enclosed software/driver, the software/driver will send
out the command, which will overwrite the setting set from the front
panel.
To Next Page
Loading...
Need help?
General
