3.1.1-2.1 Darkness:
Use this option to setup printing darkness. The available setting is from 0 to 30, and
the step is 1. Printer default density is 16.You may need to adjust your density
based on selected media.
Press and to increase/decrease the printing darkness. Press
key to enable the setting. Press key to cancel the setting and
return to the previous menu.
Note: If printing from enclosed software/driver, the software/driver will send
out the command, which will overwrite the setting set from the front
panel.
3.1.1-2.2 Print Speed:
Use this option to setup print speed. The each increment/decrement is 1 ips.
Press key to raise the print speed, and press key to decrease
print speed. Press key to set it into printer. Press key to
cancel the setting and return to the previous menu.
Note: If printing from enclosed software/driver, the software/driver will send
out the command, which will overwrite the setting set from the front
panel.
3.1.1-2.3 Tear Off:
This option is used to fine tune media stop location. Press the button to
To Next Page
Loading...
Need help?
General
