TSC TTP-346M - 3.3 Replacing the Power Supply Unit

16
16
TTP-2410M/346M/644M
TTP-246M Plus/344M Plus
Bar Code Printe
r
Service Manual
3.3 Replacing the Power Supply Unit
1. Refer to section 3.1 to remove the electronics cover.
2. Disconnect all connectors on the power supply unit.
3. Remove 2(TTP-2410M/346M) / 4(TTP-246M Plus/344 Plus) screws and 2 cable ties.
TTP-2410M/346M TTP-246M Plus/344M Plus
---- Connector
---- Screw
---- Cable tie
4. Remove/Replace the power supply unit.
5. Reassemble the parts in the reverse procedures.