TSI Instruments 3772 - HELP Commands

Firmware Commands B-9
ZV Set the scan voltages (except 3771)
Params: start => 10–10000 Volts
end => 10–10000 Volts
Example: ZV10,10000
Note: This command does not need a comma
separating the first parameter from the
command
COM2 Data after the “:” will be transmitted to serial port 2
Example: COM2:RFV (“RFV” will be transmitted to com
port 2)
D Legacy command to read accumulative time (sec) and
accumulative counts since the last time this command was
sent.
DEL Delete Flash File, path\filename (except 3771).
FORMAT Format the flash drive. This will also erase all the data stored
on the drive (except 3771). If formatting the flash drive
becomes necessary, see the instructions in Chapter 7 “Flash
Memory Card Specification”.
DIR Read the flash card directory (except 3771).
CD Change the active flash card directory (except 3771).
HELP C o m m ands
Help,Read
Help,Set
Help,Misc
Help,x where x=Command Name