Page 28 of 102
TVL 351
ISSUE 15
Code-036 CONTROL SGL Stuck Car Push.
A car call input has been kept on longer than acceptable. Check push / wiring for short circuits or stuck contacts.
User data in the event detail will give floor number for push.
[Fault]
Code-037 CONTROL SGL Stuck Down Push..
A down call input has been kept on longer than acceptable. Check push / wiring for short circuits or stuck contacts.
User data in the event detail will give floor number for push.
[Fault]
Code-038 CONTROL SGL Stuck Up Push..
A up call input has been kept on longer than acceptable. Check push / wiring for short circuits or stuck contacts.
User data in the event detail will give floor number for push.
[Fault]
Code-039 CONTROL SGL Stuck Rear Car Push..
A rear car call input has been on longer than the stuck push timer. Check push / wiring for short circuits or stuck
contacts. User data in the event detail will give floor number for push.
[Fault]
Code-040 CONTROL SGL Stuck Rear Down Push..
A rear down call input has been on longer than the stuck push timer. Check push / wiring for short circuits or stuck
contacts. User data in the event detail will give floor number for push.
[Fault]
Code-041 CONTROL SGL Stuck Rear Up Push..
A rear up call input has been on longer than the stuck push timer. Check push / wiring for short circuits or stuck
contacts. User data in the event detail will give floor number for push.
[Fault]
Code-042 SERVICES DBL On Inspection Control / Off Inspection Control.
Indicates that the control system is in Car Top Inspection Control. During this time no calls will be accepted and all
features such as Fire or Service control are disabled.
[Service]
Code-043 DOORS SGL Rear Safety Edge Overtime.
Rear Safety Edge overtime, Check door for obstruction / SE operation.
[Information]
Code-044 DOORS SGL Rear Door Open Protection Timeout.
Rear Door Open Protection Timeout, Check for door obstructions, Door Tracks, Check door limits / door operation.
[Fault]
Code-045 DOORS SGL Rear Door Nudging.
Rear Door Nudging, Check safety edge (SE), Check for door obstruction.
[Information]
Code-046 MOTION DBL Seek Next Floor Down / Seek Floor Down Found.
The lift is moving to the next floor, in the down direction.
[Information]
Code-047 MOTION DBL Diving Down / Dive Found BFR or Dive End.
Diving Down, The position from the shaft encoder has been lost, or an error in the shaft positioning equipment.
[Information]
Code-048 MOTION DBL Shaft Encoder Abs Comms Fail / Shaft Encoder Abs Comms OK.
Communications lost with absolute position encoder, check looms and shaft encoder power / fuses.
[Breakdown]
To Next Page
Loading...
