TVC Ethos Two - Page 29

Page 29 of 102
TVL 351
ISSUE 15
Code-049 DOORS SGL Rear Door Close Protection Timeout.
Rear Door Close Protection Timeout, Check for door obstructions, Door Tracks, Check door limits / locks / door
operation.
[Fault]
Code-050 MOTION DBL Diving Up / Dive Found TFR or Dive End.
Diving Up, The position from the shaft encoder has been lost, or an error in the shaft positioning equipment.
[Information]
Code-051 MOTION SGL Stopped Off Level.
The car has stopped out of floor level. Check drive/valve stopping setup and/or brake, check slowing for overshoot.
[Fault]
Code-052 DRIVE SGL Parking Failed.
Lift failed to park at the bottom floor. Check for associated faults in logger.
[Fault]
Code-053 CONTROL SGL Stuck Push Cleared..
A stuck push has been cleared.
[Fault]
Code-054 CONTROL DBL On Up Peak Duty / Off Up Peak Duty.
Lift in up peak duty traffic mode.
[Information]
Code-055 SERVICES DBL Lobby Return / Off Lobby Return.
Lift on Lobby Return Service.
[Service]
Code-056 CONTROL DBL On Down Peak Duty / Off Down Peak Duty.
Lift in down peak duty traffic mode.
[Information]
Code-057 SERVICES DBL Hospital Service / Off Hospital Service.
Lift is on Hospital Service.
[Service]
Code-058 MOTION DBL Re-Level Start / Re-Level Stopped.
The lift is on a re-level journey, this event is for information only.
[Information]
Code-059 MOTION SGL Zero/Adv Brake Problem.
Zero hold or Advance brake lift general fault, check operation sequence and GL or LGC.
[Fault]
Code-060 DOORS DBL Advance Brake Limit Fault / Advance Brake Limit OK.
Advance brake limit fault, check limits and input DAC are correct when doors are both open and closed.
[Fault]
Code-061 SERVICES DBL Emergency Recall 1 / Off Emergency Recall 1.
Lift is on Emergency Recall 1 Service.
[Service]
Code-062 MOTION SGL Leveller/Direction Error.
Leveller or Direction error, check vanes etc, brake settings for rollback, drive settings for current limit.
[Fault]
Code-063 MOTION MAN Multi Level Error / Multi Level Reset.
Leveller error on this floor 3 accumulated times, check tape head (LU/LD/DZ/DZM) signals. Clear fault in toolbox
menu.
[Breakdown]