Page 30 of 102
TVL 351
ISSUE 15
Code-064 CONTROL DBL Thermal Over/Under Temperature / Thermal OK.
Drive / Motor Room temperature sensor has tripped indicating a thermal over or under temperature issue in the
motor room. The lift will stop at the next available floor. The User Data indicates the tripped device. 1 = Drive, 2 =
Motor Room, 3 = Both.
[Breakdown]
Code-065 CONTROL SGL RTC Change To DST.
RTC has changed to DST, The CPU has automatically changed the time, due to DST rules.
[Information]
Code-066 DRIVE SGL MC Or BKR Lost High Speed.
MC or BKR feedback lost on high or medium speed, check drive safety circuit, or lock tip.
[Fault]
Code-067 DRIVE SGL MC Or BKR Lost Low Speed.
MC or BKR feedback lost on low / levelling speed, check drive safety circuit, or lock tip.
[Fault]
Code-068 SERVICES DBL Fire Recall / Off Fire Recall.
On Fire Recall the lift will return to the fire floor as soon as possible, reversing direction if needed. If the doors are
open they will nudge closed, if available, Note: the door open push and the safety edge will be ignored. When at the
fire floor the doors will open and remain open. No calls can be entered, Fire Recall Indicator output will be active.
[Service]
Code-069 SERVICES MAN Prepare To Test / Off Prepare To Test.
Lift is on Prepare to Test. The lift will not allow landing calls to be placed in the system.
[Service]
Code-070 SERVICES DBL Fire Service / Off Fire Service.
There are two phases to this service - recall and fireman's control. Once lift has recalled to fire floor it will park with
doors open and in constant pressure mode for both closing and opening. Fire officers can then control the lift by
holding a car call down until doors fully closed. Additional car calls can be placed but these will cancel any existing
call. Lift will only exit this service if signal is removed and lift is returned to fire floor and doors opened.
[Service]
Code-071 SERVICES DBL Special Service / Off Special Service.
All outstanding car calls will be cancelled and the car will park with its doors open and in constant pressure mode.
Lift will service the nearest car call placed by the user, cancelling any/all other calls on intercept. On deactivating
Car Preference the lift will automatically be taken back into group control.
[Service]
Code-072 SERVICES DBL No Dispatcher / Found a Dispatcher.
This event will be recorded if the car detects a dispatcher failure. Check the communication cable between the
controller and dispatcher and ensure the dispatcher is powered on and in service. Check landing push feed and
CAN cables.
[Breakdown]
Code-073 MEMORY SGL SRAM Synchronisation.
The SRAM parameter data area needs updating, this is an automatic function to repopulate the parameter data
area.
[Fault]
Code-074 MOTION SGL GL Lost Advance Open.
GL feedback signal was lost whilst on advance door opening, check lock circuit. This signal should be present even
if the doors are open, due to the lock bridging circuit
[Fault]
Code-075 CONTROL SGL ***Software Reset***.
Software Reset, The internal CPU has detected an illegal opcode or illegal access problem.
[Fault]
To Next Page
Loading...
