TVC Ethos Two - Page 34

Page 34 of 102
TVL 351
ISSUE 15
Code-117 CONTROL SGL RTC Change From DST.
RTC has changed from DST, The CPU has automatically changed the time, due to DST rules. Can be deactivated if
required
[Information]
Code-118 MEMORY DBL No Parameters / Parameters Ok.
The backup and user settings are corrupt. Restore to default values via button in 'Settings' menu.
[Breakdown]
Code-119 MEMORY SGL User Params Imported.
User data held on card SD 1 has been imported into Ethos Two user EEPROM memory.
[Information]
Code-120 SERVICES MAN Door Disable / Off Door Disable.
Lift is on Door Disable mode. Landing calls have been disabled
[Service]
Code-121 CONTROL SGL Logged In.
Password has been accepted.
[Information]
Code-122 CONTROL SGL Car Delayed, Calls Cancelled.
All calls have been cancelled because the car was delayed. Check for motion or door related faults.
[Fault]
Code-123 CONTROL DBL WatchDog Disabled / WatchDog Enabled.
The Watchdog has been disabled, do not run the elevator in normal under this condition, move SW7 to it's lower
position.
[Fault]
Code-124 DOORS DBL Front Door Open Fault / Front Door Open OK.
Front Door Open Fault, doors have failed to fully open. Check for Door obstructions, Door Tracks, Check door limits
/ door operation.
[Breakdown]
Code-125 DOORS DBL Rear Door Open Fault / Rear Door Open OK.
Rear Door Open Fault, Check for Door obstructions, Door Tracks, Check door limits / door operation.
[Breakdown]
Code-126 CONTROL SGL Auto Logger Reset.
The Event Logger has auto reset due to corrupt assert table file.
[Information]
Code-127 CONTROL SGL Logged Out.
User has logged out manually or the password time has expired.
[Information]
Code-128 MOTION DBL Stuck SU/SD / SU/SD OK.
Stuck SU/SD or SPX input. Lift cannot update position, check spx input switching and wiring.
[Breakdown]
Code-129 DOORS DBL Rear Door Limit Error / Rear Door Limits OK.
Rear Door Limit Error, Both Limits have been seen at the same time, check limit operation and inversion settings.
[Breakdown]
Code-130 MEMORY DBL Different Templates / Different Templates Ok.
Parameters are incompatible with software version.
[Fault]