Page 38 of 102
TVL 351
ISSUE 15
Code-173 SHAFT ENC. SGL Shaft Encoder Crash Stop.
Shaft Encoder has caused a crash stop, this is due to over-speeding whilst approaching a terminal floor.
[Fault]
Code-174 SHAFT ENC. DBL ETSD Card Shaft Map Error / ETSD Shaft Map OK Or On A Learn.
ETSD Card has a corrupt shaft map, try a shaft learn procedure (Check-List->Learn Shaft) to cure this problem.
[Breakdown]
Code-175 SERVICES DBL K-Weigh Reset Active / Off K-Weigh Reset.
Lift is on K-Weigh Reset Routine.
[Service]
Code-176 SHAFT ENC. SGL Lost - Position Error.
Car is lost and must dive to reset the position encoding equipment. User Data 1 = Main encoder, 2 = ETSD encoder,
3 = Both.
[Fault]
Code-177 SHAFT ENC. SGL Shaft Encoder Soft Reset Dive.
Shaft Encoder has a large count error and will try to call to the bottom floor to reset it's position.
[Fault]
Code-178 SHAFT ENC. DBL ETSD Card Absolute Encoder Lost / ETSD Card Absolute Encoder OK.
ETSD Card has lost communications to the absolute encoder, check etsd card and encoder.
[Fault]
Code-179 SHAFT ENC. DBL ETSD Communications Lost / ETSD Communications OK.
Lost ETSD communications; check ETSD card loop LED D1 is flashing, check job is configured for ETSD
functionality.
[Breakdown]
Code-180 SHAFT ENC. SGL Shaft Encoder Target Problem.
Shaft Encoder cannot give a speed for this run due to it being too short for lowest speed, check shaft encoder
slowing distances.
[Fault]
Code-181 DOORS SGL Ramp Lock Fail.
Ramp Lock Failure, The Ramp-Locks have opened or failed to close, Check locks at this floor front or rear.
[Fault]
Code-182 SERVICES DBL Top Final Limit Operated / Top Final Limit OK.
Up Terminal Auxiliary Limit Operated. Lift has over travelled and will recall to bottom floor
[Service]
Code-183 MOTION DBL Shaft Encoder Shaft Map Problem / Shaft Encoder Map OK Or On A
Learn.
Shaft Encoder shaft map has not been learnt correctly, repeat a shaft learn (Check-List->Learn Shaft).
[Breakdown]
Code-184 MOTION SGL AROA (DZM) Missing Stopped.
Lift has stopped and is missing DZM input, taken from AROA terminal. The lift cannot re-level without the 2nd door
zone signal.
[Fault]
Code-185 CONTROL DBL Rope Brake Fault / Rope Brake OK..
Rope brake safety signal is lost. Check the condition of the rope brake.
[Breakdown]
Code-186 SERVICES DBL Lift Isolation / Off Lift Isolation.
Lift has been isolated.
[Service]
To Next Page
Loading...
