TVC Ethos Two - Page 39

Page 39 of 102
TVL 351
ISSUE 15
Code-187 SHAFT ENC. DBL ETSD Card has pattern control / ETSD Pattern OK.
ETSD card has pattern control, this could be an ETSD, over speed condition or pattern fault.
[Fault]
Code-188 SHAFT ENC. SGL Shaft Encoder Pattern Error.
Shaft Encoder has had an error in the pattern task, consult factory.
[Fault]
Code-189 SHAFT ENC. SGL Shaft Encoder Over Speed.
Shaft Encoder has had an over speed condition, check speed / encoder settings and also SA/SB connections.
[Fault]
Code-190 SHAFT ENC. SGL Shaft Encoder Under Speed.
Shaft Encoder has had an under speed condition check encoder connections / settings and mechanics.
[Fault]
Code-191 SHAFT ENC. MAN Repeated Shaft Encoder Faults / Manual Shaft Encoder Faults
Cleared.
Shaft Encoder has had the same fault on 3 consecutive journeys, check logger to see relevant fault.
[Breakdown]
Code-192 MOTION SGL Landing Gates Fault.
Landing gates not closed whilst starting check lock circuit (GL) / door contacts etc.
[Fault]
Code-193 SERVICES DBL On Remote Recall / Off Remote Recall.
Lift is on Remote Recall Service, this is activated from E-Director.
[Service]
Code-194 MOTION SGL Brake Fail, Starting.
The brake confirmation input was not received on start-up.
[Fault]
Code-195 MOTION SGL Brake Fail, Moving.
The brake confirmation input has dropped whilst moving.
[Fault]
Code-196 MOTION SGL Brake Fail, Stopping.
The brake confirmation input has failed to drop during stopping.
[Fault]
Code-197 MOTION MAN Brake Confirm Fail / Brake Confirm Reset.
The brake confirmation input has failed and the panel has shut down. Clear the fault manually in the solutions menu.
[Breakdown]
Code-198 SERVICES DBL On Urine Detection / Off Urine Detection.
Lift is on Urine Detection. Lift will be recalled to a designated floor and await cleaning
[Service]
Code-199 DRIVE SGL MC Or BKR Lost Zero.
MC or BKR feedback lost on zero speed, check drive settings and safety circuit.
[Fault]
Code-200 SERVICES DBL On Limited Floor Service / Off Limited Floor Service.
Limited Floor Service, Lift will not stop at floors secured by this map. Usually a 'timed' service, check parameters for
details
[Information]
Code-201 CONTROL DBL Car Network Fail / Car Network OK..
The serial car network has a problem, check view I/O screens for module status.
[Breakdown]