TVC Ethos Two - Page 40

Page 40 of 102
TVL 351
ISSUE 15
Code-202 CONTROL DBL Landing Network Failed / Landing Network Working.
The serial landing network has a problem, check view I/O screens for node status.
[Breakdown]
Code-203 CONTROL DBL CAN3 Bus Off / Error Passive / CAN3 Bus On / Bus OK.
The CAN3 Controller (Abs Encoder / Landing Net.) is not transmitting. Check termination resistors are correct, check
baud-rate and wiring.
[Fault]
Code-204 CONTROL DBL CAN4 Bus Off / Error Passive / CAN4 Bus On / Bus OK.
The CAN4 Controller on the ETSD Card (Abs Encoder) is not transmitting. Check termination resistors are correct,
check baud-rate and wiring.
[Fault]
Code-205 SERVICES DBL Milkman's Service / Off Milkman's Service.
Lift is on Milkman's service control.
[Service]
Code-206 SHAFT ENC. SGL SE Absolute Encoder Error.
Shaft Encoder, Absolute CAN encoder count error, check that the encoder's bearing is not failing or limax tape is
defective.
[Fault]
Code-207 SERVICES DBL UPS Recall / Off UPS Recall.
Lift is running on UPS.
[Service]
Code-208 MOTION DBL Contactor Mon.Stuck / Contactors OK.
The main MC or STR Contactor maybe stuck in or stuck out, check contactor or wiring.
[Breakdown]
Code-209 MOTION MAN Contactor Check Fail / Contactors Fail Rst..
The main MC or STR Contactor is stuck in, check contactor or wiring. Will need a manual reset via the Solutions
screen
[Breakdown]
Code-210 MOTION DBL Drive Communications Fail / Drive Communications OK.
Communications lost with drive, check looms and drive power / fuses.
[Breakdown]
Code-211 DRIVE DBL Drive Fault / Drive OK.
The drive has an active fault, drive fault bit is set in the comms, check drive and clear fault.
[Breakdown]
Code-212 MOTION SGL TUP/DN or EEOU/D Fault.
TUP-TDN or EEOU/EEOD test direction inputs, have been seen on normal operation, check for wiring faults, serial
drive control only.
[Fault]
Code-213 CONTROL DBL Lift Alert Signal / Lift Alert Signal OK.
Lift Alert signal is lost. Check the status of the OSG.
[Breakdown]
Code-214 SERVICES DBL Emergency Recall 2 / Off Emergency Recall 2.
Lift is on Emergency Recall 2 Service.
[Service]
Code-215 SERVICES DBL Emergency Recall 3 / Off Emergency Recall 3.
Lift is on Emergency Recall 3 Service.
[Service]