EasyManua.ls Logo

TVC Ethos Two - Page 42

Default Icon
102 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 42 of 102
TVL 351
ISSUE 15
Code-231 MOTION DBL Seek Next Floor Up / Seek Floor Up Found.
The lift is moving to the next floor, in the up direction.
[Information]
Code-232 MOTION DBL Parking / Parking End.
The car is homing (parking) to a predefined floor level after a period of idleness.
[Information]
Code-233 DOORS DBL Front Door Lock Test Request / Front Door Lock Test Complete.
The front door lock circuitry is being tested. Also known as a Preflight check.
[Information]
Code-234 DOORS DBL Rear Door Lock Test Request / Rear Door Lock Test Complete.
The rear door lock circuitry is being tested. Also known as a Preflight check.
[Information]
Code-235 MOTION MAN Manual Events Reset / Manual Events Reset Acknowledged.
All manually resettable events have been restored, this event must be acknowledged. Button to reset can be found
in the Solutions screen
[Breakdown]
Code-236 SERVICES DBL Awaiting Car Call / Car Call Pressed.
Fault active that requires car call to try to put the lift back in service, press any car call.
[Breakdown]
Code-237 CONTROL DBL SD1 Card Absent / SD1 Card Detected.
SD1 card is missing, please insert a micro SD card into slot SD1. Without a card event data will not be recorded
[Information]
Code-238 CONTROL DBL SD1 Card Error / SD1 Card Okay.
Card error, User Data field provides card and error code, contact TVC for assistance
[Information]
Code-239 CONTROL SGL SD1 Card Formatted.
The SD1 card was invalid and has successfully been formatted.
[Information]
Code-240 CONTROL DBL SD1 Card Full / SD1 Card Not Full.
SD1 card is full, please make more space available.
[Information]
Code-241 CONTROL DBL Car Network Fault / Car Network OK..
The serial car network has a problem, check car node alive screens.
[Fault]
Code-242 MOTION SGL Contactor Mon.Stuck.
The main MC or STR Contactor maybe stuck in, check contactor or wiring.
[Fault]
Code-243 MOTION SGL LTLR Tripped.
Low Speed Time Out has timed, check levellers, check for motor stall at low speed, check drive torque settings or
LTLR timer.
[Fault]
Code-244 CONTROL DBL Hyd Thermal Recall / Off Hyd Thermal Recall.
Motor room temperature sensor has tripped, car will recall to bottom floor.
[Service]
Code-245 CONTROL MAN Top Final Shutdown / Top Final Limit Reset.
Up Terminal Auxiliary Limit Operated. Lift over travelled and was shut down!
[Breakdown]

Table of Contents

Other manuals for TVC Ethos Two