Page 46 of 102
TVL 351
ISSUE 15
Code-287 SERVICES MAN Overspeed Test Mode / Off Overspeed Test Mode.
The lift has been placed in Overspeed Test mode. Warning: The lift will run at a speed above normal, make sure it's
safe to do so.
[Service]
Code-288 SERVICES MAN Buffer Test Mode / Off Buffer Test Mode.
The lift has been placed in Buffer Test mode. Warning: The lift will run at buffer test speed into the buffers, make
sure it's safe to do so.
[Service]
Code-289 SHAFT ENC. SGL Shaft Encoder Speed Deviation Fault.
Poor hoist motor control, use the Profile Display. Check drive config and Pattern Speed Error Tolerance in settings.
[Fault]
Code-290 SHAFT ENC. SGL Shaft Encoder Voltage Deviation Fault.
Analogue pattern problem, use the Profile Display. Check Pattern Volts Error Tolerance in settings.
[Fault]
Code-291 CONTROL DBL Drive/Motor Over Temperature / Drive/Motor Temperature OK.
The drive temperature sensor or motor thermistor has tripped indicating a thermal over temperature issue.
[Information]
Code-292 CONTROL DBL Ambient Over/Under Temperature / Ambient OK.
The Ambient temperature sensor has tripped indicating a thermal over or under temperature issue.
[Information]
Code-293 SERVICES DBL On Pit Inspection Control / Off Pit Inspection Control.
Indicates that the control system is in Pit Inspection Control. During this time no calls will be accepted and all
features such as Fire or Service control are disabled.
[Service]
Code-294 MOTION MAN Multiple Off Level Events / Multi. Off Level OK.
The car has stopped out of floor level. Check drive/valve stopping setup and/or brake, check slowing for overshoot.
[Breakdown]
Code-295 SERVICES DBL UPS Device Failure / UPS Device OK.
Lift is on Recall Service for UPS Device Failure.
[Service]
Code-296 SERVICES SGL Car Alarm Pressed.
The in car alarm push has been pressed for over 3 seconds.
[Information]
Code-297 SERVICES DBL Passenger Trapped / Passenger Released.
A passenger is potentially trapped within a broken-down car.
[Information]
Code-298 CONTROL DBL EMU Gateway Log In / EMU Gateway Log Out.
The EMU Gateway log in key switch has been set, release key switch to log out of the EMU Gateway. Only
applicable if EMU Gateway fitted to expansion bus.
[Information]
Code-299 SERVICES DBL Limax3CP OC/Reset Test Active / Off Limax3CP OC/Reset Test.
Lift is on Limax3CP Reset Routine. This feature is performed at least twice a day, the OC contact of the Limax will
be cycled.
[Service]
Code-300 SHAFT ENC. DBL Limax3CP Teach Mode / Limax3CP Normal Mode.
Limax3CP is in teach mode. In this mode the reference positions and floors can be taught in.
[Service]
Code-301 SHAFT ENC. DBL Limax3CP Test Mode / Limax3CP Normal Mode.
Limax3CP is in test mode. In this mode the ETSL up or down feature can be tested.
To Next Page
Loading...
