6 Printing Operation
!
Attention!
Printhead damage is caused by improper handling!
Do not touch the underside of the printhead with ngers or
sharp objects.
Ensure the media is clean by storing in a clean environment.
The printer is ready for operation when all of the connections have been
made, and the media and the transfer ribbon has been loaded.
6.1 Printing in Tear-off Mode (For Labels only)
After printing, the label can be torn-off manually. The printer is equipped with a
tear-off plate for this purpose.
6.2 Printing in Cutting Mode
The printer can be equipped with a cutter or perforator, to cut off or perforate
labels or continuous media automatically after printing.
6.3 Synchronizing the Media Feed
After the media has been inserted for cutting, calibration (synchronization) is
required. The rst media section detected by the media sensor is transported
to the print position, with all media sections before being fed out of the printer.
This calibration (synchronization), will avoid an incorrectly cut media section
length (too long).
Press to start the calibration (synchronization).
Remove the blank media sections cut during the calibration
(synchronization).
i
Notice!
Calibration (synchronization) is not necessary if the printhead was
not opened between different print jobs, even if the printer was
switched off.
To Next Page
Loading...
