• When the printer is in operation the cover must be closed. However when
loading or operating the printer, ensure all loose clothing, long hair, jewelry
etc, do not come into contact with the exposed rotating parts.
• The printer or parts of it can become hot while printing. Do not touch
during operation, and allow to cool down before changing media and
before disassembly.
• Risk of crushing when closing the cover. Touch the cover at the outside
only. Do not reach into the hinge range of the cover.
• Perform only those actions described in this operating manual.
Work going beyond this may only be performed by trained personnel or
service technicians.
• Unauthorized interference with electronic modules or their software can
cause malfunctions.
• Other unauthorized work on or modications to the printer can also
endanger operational safety.
• Always have service work done in a qualied workshop, where the
personnel have the technical knowledge and tools required to do the
necessary work.
• There are various warning stickers on the printer. They draw your attention
to dangers.
Warning stickers must therefore not be removed, as then you and other
people cannot be aware of dangers and may be injured.
• The maximum sound pressure level is less than 70 dB(A).
Danger!
Danger to life and limb from power supply.
Do not open the printer casing.
1.6 Environment
Obsolete printers contain valuable recyclable materials that should be sent
for recycling.
Send to suitable collection points, separately from residual waste.
The modular construction of the printer enables it to be easily disas-
sembled into its component parts.
Send the parts for recycling.
The electronic circuit board of the printer is equipped with a lithium battery.
Take old batteries to collection boxes in shops or public waste disposal
centers..
1 Introduction
To Next Page
Loading...
