7 Maintenance
9
10
11
5
8
7
8
7
5
6
Fig. 18 Replace Blades
1312
Fig. 19 Springs
4. If the blades are very dirty with residues of adhesive or if they are worn,
change blades:
Turn the shaft (6) clockwise using a torx wrench TX10 until the gear
racks (7) no longer engage.
Pull the upper blade (9) out of the guides (8).
Take out the lower blade (10).
Remove deposits from the blades with TE approved cleaning
materials.
If necessary, replace blades.
Push the lower blade down into the guides (11).
If necessary, put springs (12) back into spring retainers (13).
To re-mount the upper blade push the lower blade down on the cover
and push the upper blade into the guide until the gear racks (7) can
engage with the gear wheels (5).
Turn the shaft (6) counterclockwise using a torx wrench TX10 until the
blade reaches the upper limit.
5. Fit the blade unit (3) according to Fig. 17 into the axes (2) and fold it
towards the cover (4) until it snaps in.
6. Fold the cutter / perforator up to the print unit.
To Next Page
Loading...
