will slightly brake and fall.
9. The 850 joint module has brakes inside, which
will remain manipulator’s pose when a power
outage occurs.
10. When the robotic arm is in operation, make sure
no people or other equipment are in the working
area.
11. When releasing the brakes of 850, please take
protective measures to prevent the robotic arm
or operator from damage or injury.
12. When connecting the 850 with other machinery,
it may increase risk and result in dangerous
consequences. Make sure a consistent and
complete safety assessment is conducted for the
installation system.
1. The robotic arm and Control Box will generate
heat during operation. Do not handle or touch
the robotic arm and Control Box while in
operation or immediately after the operation.
2. Never stick fingers to the connector of the end-
effector.
1. Make sure the robotic arm’s joints and tools are
installed properly and safely, and check the
status for all circuits.
2. Make sure that there is enough space for the
manipulator to move freely.
To Next Page
Loading...
