____________________________________________________________________________________________
Page 10/63 UltraGauge™ EM User Manual www.ultra-gauge.com
****
Display will remain on while in the menu system. Always exit the menu system when the ignition is in the OFF position.
Installation
The Basic installations steps are as follows:
1. Choose method of mounting; Custom, Hook & Loop, vertical, horizontal or windshield mount
2. Install the mount
3. Attach UltraGauge to the mount
4. Optionally coil extra cable near UltraGauge to allow UltraGauge to be disconnected from mount and conveniently
configured
5. Route the remainder of the cable such that it is tucked away and does not interfere with vehicle controls, such as steering,
wiper control, transmission shifter, turn signal, foot controls, and does not represent a hazard to vehicle entry or exit.
6. Turn the ignition to the RUN position. (The ignition has four positions: OFF, ACC, RUN & START. You do not need to
start the vehicle)
7. Connect the UltraGauge OBD II connector to the OBD II connector on the vehicle
8. UltraGauge will then determine the vehicle’s protocol and discover the available gauges.
Detailed Installation instructions
Choose method for mounting; Hook & Loop, vertical, horizontal or windshield mount. The Hook & Loop mount has the
advantage that it can be used to attach in areas less visible from outside the vehicle, reducing the risk of vandalism and theft.
The Hook & Loop mount is also less likely to lose attachment over time and is inherently less obstructive.
The windshield mount has the advantage that it typically positions UltraGauge in an area that is closer to the view of the road
and hence potentially represents less interruption to driving concentration. The windshield mount can also be attached to any
smooth surface and is therefore not limited to the windshield.
Hook & Loop
The hook and loop fastener, commonly known as Velcro™, is comprised of two halves, each is 1"x1.5". One half is attached to the back
of UltraGauge, as shown above. The 2nd half is attached to a surface inside the vehicle, such as the dash. The fastener may be used as-is
or trimmed in size or cut in to several pieces. Each half has an adhesive that can be applied to any clean, solid surface. The fastener is
an industrial strength Hook & Loop which can withstand temperatures as high as 250F (121C) without lifting or shearing from the
attached surface.
Width 1"
Length ~1.5"
Thickness mated 0.15"
Color Black
Temperature range -20F - 250F
To Next Page
Loading...
