EasyManuals Logo

Ultratec CapTel 2400iBT User Manual

Ultratec CapTel 2400iBT
106 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #105 background imageLoading...
Page #105 background image
Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two
conditions:
1. This device may not cause harmful
interference, and
2. This device must accept any interference
received, including interference that may
cause undesired operation.
Warning (Part 15.21)
Changes or modication not expressly approved
by the party responsible for compliance could
void the user’s authority to operate the equipment.
FCC Interference Statement (Part 15.105b)
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates
uses and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment o and on, the user is encouraged to
try to correct the interference by one of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment to an outlet on a
circuit dierent from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV
technician for help.
RF Exposure (OET Bulletin 65)
To comply with FCC/IC exposure requirements
for mobile transmitting devices, this transmitter
should only be used or installed at location
where there is at least 20 cm separation distance
between the antenna and all persons.
To comply with FCC/IC RF exposure limits for
general population/uncontrolled exposure, the
antenna(s) used for this transmitter must be
installed to provide a separation distance of at
least 20 cm from all persons and must not be
co-located or operating in conjunction with any
other antenna or transmitter.
Customer Service: 888-269-7477 FCC INFORMATION 103

Table of Contents

Other manuals for Ultratec CapTel 2400iBT

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ultratec CapTel 2400iBT and is the answer not in the manual?

Ultratec CapTel 2400iBT Specifications

General IconGeneral
BrandUltratec
ModelCapTel 2400iBT
CategoryTelephone
LanguageEnglish

Related product manuals