CRANKCASES
Fit:
- The engine crankcase gasket (1) (new gasket).
Fit:
- The left-hand crankcase (2) onto the right-hand crankcase
(3), being guided by the centring studs (4).
ATTENTION
MAKE SURE THAT THE GASKET REMAINS IN THE CORRECT
POSITION.
N.B.:
TAP THE CRANKCASE LIGHTLY WITH A PLASTIC HAMMER.
IMPORTANT
TIGHTEN THE BOLTS ON THE BLOCK IN SUCCESSION
CROSSWISE, GOING FROM ONE TO ANOTHER TWO OR
THREE TIMES.
Fit:
- The 6 outer bolts (5) on the left-hand crankcase.
- The (longer) outer bolt (6) on the left-hand crankcase.
- The 6 inner bolts (7) on the left-hand crankcase.
Bolts (crankcases):
1,1-1,3 kgf.m (11-13 N.m)
2
1
4
3
5
7
5
7
5
6
66
ASSEMBLING THE ENGINE
AND ADJUSTMENTS
WORKSHOP MANUAL
To Next Page
Loading...
