United Parachute Technologies Vector 3 - Appendix F: Closing the Main Container - Previous Methods

VECTOR3MANUAL
MAN‐004REV7.2937/20/2017
APPENDIX F: CLOSING THE MAIN CONTAINER – PREVIOUS METHODS

METHOD1–BRIDLEROUTINGFROMBOTTOMOFTHECONTAINER

Instructionsforusingthepreviousbridledesign
routedfromthebottomofthecontainer.

Closethemaincontainerfollowingnorma l
methodsmakingsurethebridleisexitingthe
bottomofthecontainerattherightmainflap.


Insertthe
closingpin(locatedonthebridle)
throughtheclosingloopfromlefttoright.The
greenindicatoronthebridleshouldfacing
down.


CovertheunusedhookVelcrowithpileVelcro.
Slowlyremovethepull‐upcordtoprevent
excessfrictionfromdamagingtheclosingloop.



Ensurethegrommetsareoffsetasshown.






Ensurethegrommetsareoffsetasshown.
Stowthebridleundertherightclosingflapas
indicated.
Notethatthegrommetsdonotline
up,thebindingtapesshouldstack.Itmaybe
necessarytoadjustthelengthoftheclosingloop
tomaketheflapsalignproperly.



Closethemainpincover.




UnusedVelcro
Tuckthebridle
underrightmain
sideflap.