United Parachute Technologies Vector 3 - Setting up the Pull-Out Deployment System; Setting up the Pull-Out Deploment System

VECTOR3MANUAL
MAN‐004REV7.2577/20/2017

SETTING UP THE PULL-OUT DEPLOYMENT SYSTEM

WhenaVector3istobesetupwiththepull‐
outmaindeploymentsystem,thebridle/pinand
handlesetupmustfirstbeattachedtothepilot
chute.Todothis,performthefollowing:

1.First,threadtheendofthebridlewithno
hookandloopfasteneron
itthroughtheloop
locatedonthehandle/pinsetup.

2.Next,threadtheendofthebridlethrough
thecrossedtapeandcenterlineatthebaseof
thepilotchute.











3.Finally,threadtheendofthebridleback
throughtheoppositeendofthebridle.
















