United Parachute Technologies Vector 3 - Placing the Bag in the Reserve Container (with Staging Loop & Skyhook)

VECTOR3MANUAL
MAN‐004REV7.2327/20/2017

PLACING THE BAG IN THE RESERVE CONTAINER ( WITH OPTIONAL STAGING LOOP & SKYHOOK)

*FORPROCEDUREWITHOUTSTAGINGLOOPAND
SKYHOOK,SEEPAGE38.
1.Placethebaggedcanopyonthemaincontainer
andpositionthereserverisersinthereservepack
tray.Fanthelinksratherthanstackingthemon
eachother,placingtherearlinkstotheoutside.Be
suretoplace
thereserverisersfarenoughinthe
packtraysotheywilllieflatovertheshoulders.

2.Passapull‐upcordthroughthereserveclosing
loopandasecondpull‐upcordthroughtheshock
cordstagingloopasshown.

NOTE:
Thepre‐stretchedreserveclosingloopwill

measure4½”+/‐½”.
Colorcodedpull‐upcordsarehelpful.

NOTE:
Regardlessofthelooplength,thestagingloopwill
alwaysbe1”shorterthantheCypresloop.This
ensurespropertensiononthereservebridleforall
V3models.
3.Passbothpull‐upcordsthrough
thebodkinand
pullthroughtothetopside.

1”
NOTE
If a T‐bar was passed through the bag,
threadtheendsof the pull‐up cordthrough
theholeintheendoftheT‐bar.
RemovetheT‐barfrom the bagged canopy,
pulling the closing loop and pull‐up cord
throughit.