United Parachute Technologies Vector 3 - Installing the R.s.l. (Reserve Static Line) -No Skyhook

VECTOR3MANUAL
MAN‐004REV7.2467/20/2017

INSTALLING THE R.S.L. (RESERVE STATIC LINE) ‐NOSKYHOOK 
1.InspecttheRSL:Checkthestainless‐steelsnapshackleisoperatingsmoothlyandthatthespringwillretainthe
lockingpin.Checkthatthehookandloopfasteneriscleanandsufficientlytackytoholdthereservelanyardinplace.
Thepinshouldbecurvedfromtheeyetohalf
waydownitslength.Therestofthepinshouldbestraight.

2.StartbyroutingtheRSLalongitshookand
loopfastenerpathalongsidetheright‐hand
riser.
3.InserttheRSLpinthroughtheloopattheend
ofthereserveripcordcable;ensurethepinruns

thesamedirectionasthecutinthemarineeye.
Replacethetemporarypinwiththereservepin.
Removethepull‐upcord.


5.Ensuretheyellowreleasecablepasses
throughtheCollinslanyard.










NOTE
RSLsshouldonlybeinstalledbyaqualified
rigger.
Matethepatchof5/8”pilehookand
loopfasteneronthetop#6reserveflap.
RSLLanyard
Collinslanyard
NOTE
ForolderstyleVectorswiththeringonflap6,pleaserefertotheappendixofthismanual.