United Parachute Technologies Vector 3 - Section 4: Main Canopy Assembly and Packing Procedures

VECTOR3MANUAL
MAN‐004REV7.2417/20/2017

PLACING THE BAG IN THE CONTAINER (WITHNOSTAGINGLOOPORSKYHOOK)

1.Placethebaggedcanopyonthemain
containerandpositionthereserverisersinthe
reservepacktray.Fanthelinksratherthan
stackingthemoneachother,placingtherear
linkstotheoutside.Besuretoplacethereserve
risersfar
enoughinthepacktraysotheywilllie
flatovertheshoulders.

NOTE:Thepre‐stretchedreserveclosingloop
willmeasure4½”+/‐½”.

2.Passthepull‐upcordthroughthereservebag
asusual.
3.Placethebaggedcanopyinthepacktray,
takingextracare
tofillthelowercorners.Then
usethepull‐upcordtopulltheclosingloopup
throughthebaggedcanopy.Secureitwitha
temporarylockingpin

CLOSING THE CONTAINER
Thereserveflapsarenumbered1‐6for
reference.Closetheminpropersequence.

NOTE
If a T‐bar was passed through the bag,
thread the ends of the pull‐up cord
throughtheholeintheendoftheT‐bar.
Remove the T‐bar from the bagged
canopy,pullingtheclosingloopandpull‐
upcordthroughit.