Need help?Do you have a question about the United Parachute Technologies Vector 3 and is the answer not in the manual?
Provides essential pre-jump considerations and warnings for users of the Vector 3 system.
Guides the user on installing an AAD into the Vector 3 harness and container system.
Outlines the essential inspection steps for the reserve parachute and its system components.
Guides the user through the flaking, folding, and stacking of the reserve canopy using the Pro Pack method.
Details how to inspect and attach the main canopy to the main risers.
Explains the procedure for attaching main canopy steering toggles, noting line type differences.
Guides the user on attaching the main deployment bag and pilot chute to the canopy bridle.
Describes how to cock the main pilot chute for correct deployment function.
Details the setup of the bridle and pin for a pull-out main deployment system.
Provides step-by-step instructions for closing the main container after packing the deployment bag.
Provides instructions for assembling the Booth 3-Ring release system components.
Details the critical pre-jump checks for the Booth 3-Ring release system.
Recommends detailed rig inspections, including specific areas like the cutaway and reserve systems.
Provides a logical, top-to-bottom check sequence for the parachute equipment before a jump.
Guides the user on properly putting on and adjusting the Vector 3 harness for a snug and comfortable fit.
General| Brand | United Parachute Technologies |
|---|---|
| Model | Vector 3 |
| Category | Accessories |
| Language | English |
To Next Page