United Parachute Technologies Vector 3 - Donning and Adjusting the Vector 3

VECTOR3MANUAL
MAN‐004REV7.2857/20/2017

DONNING AND ADJUSTING THE VECTOR 3

TheVector3isdesignedsothatitfitssnugly,yetcomfortably,whentheharnessisproperlyadjusted.

PickuptheVector3usingthemainliftwebclosetowherethe3‐Ringsarelocated.PutonyourVector3inthesame
wayyouwouldputona
coat.

1.Threadingthecheststrap:Thecheststrap
enterstheadjusterfrombehind(closesttothe
jumper’schest),aroundtheslidingbar,andback
throughbetweenthebarandtheendofthe
adjuster.Adjustitsothemainliftwebsare
parallelwhenthecheststrapistight.
Stowthe
endthroughtheblackelastickeeper.Anun‐
stowedrunningendwillcausemajorslippage.


2.Checkthelegstrapsfortwistsbefore
threadingthem.Makesureyouroutethe
webbingcorrectlybeforetighteningthemuntil
theyaresnug.Slidetheexcessstrapthrough
theblackelastic
keepersprovidedandthen
stowtheexcessstrapinthepocketsontheleg
pads.Thiswillensurethatthelegstrapsdon’t
flaparoundintheairwhileyouareinfreefall. 












WARNING
Improper threading of the chest strapmay
result indeath.Death hasoccurred from a 
skydiverfallingoutoftheharnessduetoan
improperlyfastenedcheststrap.