United Parachute Technologies Vector 3 - Page 91

VECTOR3MANUAL
MAN‐004REV7.2847/20/2017
 Makesurethebridleisroutedcorrectlyfromtheclosingpin,undertheright‐
handflapalongthemainliftwebandintothepilotchutepouch.
Whenasking
anotherjumperforapincheck,makesuretheyalsofollowproper
procedures.


 Checkthe3‐Ringreleasecutawayhandle.Thehookandloopshouldbemated
correctly.Nomorethan½inch(1.2cm)ofyellowcableshouldbevisible
betweenthecutawayhandleandthecablehousings.
 IfyouhaveanAADinstalled,makesurethatyouswitchiton
pertheinstructionsprovidedbythe
manufacturer.
 
WARNING
Routing the bridle
around the leg strap
will cause a pilot
chute‐in‐tow
malfunction.