United Parachute Technologies Vector 3 - Attaching the Main Canopy to the Main Risers; Attaching the Main Steering Toggles

VECTOR3MANUAL
MAN‐004REV7.2427/20/2017

4.Closetheinsidebottomkickerflap(Flap#1)
andsecureitwiththetemporarypin.






5.Foldfirsttwothirdsofthebridlebymaking
longS‐foldsintheVshape
asshown.Carefully
tuckthebottomoftheS‐foldedsectionunder
theinsidebottomkickerflap(Flap#1).













6.Closetheinsidetopkickerflap(Flap#2)andsecureitwiththetemporarypin.Thebridleshould comeoutbetween
Flap#1andFlap#2.
Checktheamountoffree
bridleextendingfromtheclosedflapstothe
baseofthepilotchute;theremustbeatleast5
feet(1.5m).Ifthereislessthan5feet(1.5m),
reopentheflapsandre‐stowtheS‐foldedbridle
tomakethelengthoffree
bridleatleast5feet
(1.5m),maximum6feet(1.8m)long.

NOTE
Ifthestagingloopisnotgoingtobe used,
disregardthestagingloopgrommetinthe
followingfewsteps.
NOTE
Ifthereservecontainerhasthe2aSkyhook
flap installed, just close it simultaneously
withflap2.