United Parachute Technologies Vector 3 - Page 40

VECTOR3MANUAL
MAN‐004REV7.2337/20/2017
4.Placethebaggedcanopyinthepacktray,
takingextracaretofillthelowercorners.

Pullfirmlyonbothpull‐upcordstoensuregood
separationofthe2loops.



Usingyourknee,
begintoproduceroomforthe
reservepilotchutebypushingcanopyfabric
awayfromwhereitwillseat.



Thereserveflapsarenumbered1‐6for
reference.Closetheminpropersequence.
Skyhookequippedrigswillhavetheadditional
2Aflap.



NOTE
When preparing the container for the
bag, turn the upper reserve corners
insideout.
 This allows the reserve bag and
canopy to drop straight down into
thecontainer.
 It also makes it easier to fill the
bottomcornersofthecontainer.
 Leave the upper corners turned
inside out
until it is time to close
flaps#4and#5.