United Parachute Technologies Vector 3 - Page 44

VECTOR3MANUAL
MAN‐004REV7.2377/20/2017

11.Passasinglelengthofriggerssealthread
throughtheholesinthelexancoversandfirmly
tieoffwithasurgeonknottoholdtheRED
Skyhooklanyardinplace


12.Insert
theGREENflex‐tabonthefree‐bagbridle
intotheGREENpocketonthe#2flap.






13.CompletetheSkyhookassemblytothediagramonflap2A.

Closeandpinflap2AthenS‐foldremaining5’
(1.52m)ofbridlelineasshown
NOTE
CHECKRESERVERISERPLACEMENT
BEFORECLOSINGFLAP#2
The Skyhook has a Lexan cover piece
designedto:
 Hinder anything but the Skyhook
LanyardfromenteringtheHook‐slot.
 Lower the chance that the hook area
might be damaged by use or misuse.
Make sure this cover is in good

condition.Makesurethehookareais
smoothandfreeofburrs.