UAD Powered Plug-Ins Manual - 344 - Chapter 38: RealVerb Pro
To pan the direct (dry) signal:
1. Drag the Direct slider left or right. A value of <100 pans the signal hard
left; a value of 100> pans the signal hard right. A value of <0> places the
signal in the center of the stereo field.
Set the positioning for the early reflection or late-field reverberation with any of the
following methods:
1. Drag the left and right slider handles to adjust the stereo width. The length
of the blue slider is adjusted. For a full stereo signal, drag the left handle all
the way to left, and right handle all the way to the right.
2. Drag the blue center of the slider left or right to set the positioning of the sig-
nal. If you drag all the way to the left or right, the stereo width is adjusted.
For a mono signal panned hard left or right, drag the slider all the way to
the left or right.
Distance RealVerb Pro allows you to control the distance of the perceived source with
the Distance control in the Positioning panel (see Figure 111). In reverberant
environments, sounds originating close to the listener have a different mix of
direct and reflected energy than those originating further from the listener.
To adjust the distance of the source:
1. Drag the Distance slider to the desired percentage value. Larger percent-
ages yield a source that is further away from the listener. A value of 0%
places the source as close as possible to the listener.
Wet/Dry Mix The wet and dry mix of the reverb is controlled from the Mix slider in the Po-
sitioning panel (see Figure 111). The two buttons above this slider labeled “D”
and “W” represent Dry and Wet; clicking either will create a 100% dry or
100% wet mix.
To Next Page
Loading...
Need help?
General
