Program P4:
Program P5:
Program P6:
To change this setting:
1. Press OK and the parameter starts flashing.
2. Use buttons - or + to select program.
Select between: P1–P6, U and Off.
Program U
2.1 The current day starts flashing.
Decide to program a schedule in one of two
ways:
Single day: Program only a single day.
Full week: Program every day ir the week.
Single day programming:
2.1.1 Use buttons - or + to select a day for
programming.
2.1.2 Press and hold the OK button until the hours
appear.
2.1.3 The hours starts flashing. Use buttons - or
+ to set an interval for Comfort/ECO mode.
Icons in the display show which mode is
activated:
= Comfort mode
= ECO mode
Press OK to confirm each setting except
when marker, at the bottom of the screen,
reaches end of day, which will confirm the
interval.
2.1.4 When the day is fully programmed, the
software exits to the settings menu.
2.1.5 Repeat from step 1 if more days are to be
programmed.
Full week programming:
2.1.1 Press and hold the OK button until the hours
appear.
2.1.2 The hours starts flashing. Use buttons - or
+ to set an interval for Comfort/ECO mode.
Icons in the display show which mode is
activated:
= Comfort mode
= ECO mode
Press OK to confirm each setting except
when marker, at the bottom of the screen,
reaches end of day, which will confirm the
interval.
2.1.3 When the day is fully programmed, the next
day icon starts flashing and the text Copy
Yes appears. (Yes is flashing).
2.1.4 Select Yes to copy the setting of the current
day to the next.
Select No to create a new scheduling interval
for the following day.
2.1.5 Repeat steps 2.1.2 through 2.1.4 until all
available days are programmed.
2.1.6 Press OK to confirm the change and return to
the settings menu.
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
69
UPONOR SMATRIX WAVE/WAVE PLUS
· INSTALLATION AND OPERATION MANUAL
To Next Page
Loading...
Need help?
General
