Uponor SmatrixMove User Manual

8 – Wireless thermostat 1 configuration
8
This parameter is only available if parameter 5 –
Thermostat selection is set to rF (Move PLUS only).
Register a wireless thermostat to the controller.
NOTE!
When registering a thermostat to the
controller (Move PLUS only), run mode
changes parameter 0 (type) to rEv,
regardless of previous setting. Heating/
cooling is then controlled by the thermostat,
or the integrated system.
To register a thermostat:
1. Use buttons - or + to change the parameter to INI.
The controller is now set in wireless registration
mode.
8
2. Register the thermostat.
3. When the current room temperature is shown, press
the OK button to confirm the registration.
8
See section 6.9 Register a thermostat to the controller
for more information.
9 – Wireless thermostat 2 configuration
9
This parameter is only available if parameter 5 –
Thermostat selection is set to rF, and parameter 4 – Type
of system is set to 2P.1 or 2P.2.
Register a second wireless thermostat to the controller,
for use in systems with two circulation pumps (panel
heaters or fan coils).
NOTE!
When registering a thermostat to the
controller (Move PLUS only), run mode
changes parameter 0 (type) to rEv,
regardless of previous setting. Heating/
cooling is then controlled by the thermostat,
or the integrated system.
To register a thermostat:
1. Use buttons - or + to change the parameter to INI.
The controller is now set in wireless registration
mode.
8
2. Register the thermostat.
3. When the current room temperature is shown, press
the OK button to confirm the registration.
8
See section 6.9 Register a thermostat to the controller
for more information.
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
50
UPONOR SMATRIX MOVE/MOVE PLUS · INSTALLATION AND OPERATION MANUAL

Uponor SmatrixMove Specifications

General

Brand	Uponor
Model	SmatrixMove
Category	Temperature Controller
Language	English