UPPAbaby Rove - Lap Belt Only Use

1 2
64
Forward-Facing Installation – Lap Belt Only Use
1 Open lock-o door.
2 Ensuring there is no twisting in the vehicle
belt, route the lap belt through the lock-o
door and along the RED FORWARD-
FACING path. Buckle.
3 Apply pressure into seating surface, as
shown, and pull up on excess belt webbing
to remove slack from the lap belt.
(steps 3-4 illustrations on next page)
4 Close the bottom section of the lock-o
door over the lap/shoulder belt.
Close the top section of the lock-o door
over the belt. Make sure you push the
bottom of the lock-o door all the way
down until you hear an audible click
4A
.
Note: After closing the lock-o door,
the Tightness Indicator. window will turn
from RED TO GREEN
4B
. If it does not,
unbuckle and return to step 2.