66
To Access Lower Anchor Connectors
(Steps 1-4 - illustrations on next page)
1 To access Lower Anchor Connectors unsnap fabric over front panel of Child Restraint. Open the storage compartment
and pull out the Lower Anchor Connectors.
2 Lengthen the Lower Anchor Connector to maximize length by pushing the Lower Anchor Connector button downward
and pulling to full extension.
3 Raise headrest to maximum height by pushing down and pulling up on handle.
4 Unfasten back fabric panel to expose RED FORWARD-FACING Belt Path. Guide Lower Anchor Connectors under fabric
opening and pull through.
ATTENTION: This Child Restraint cannot be installed using lower anchors LATCH) for FORWARD-FACING
installation when your child exceeds 45 lbs (20.4 kg). If your child weighs over 45 lbs (20.4 kg) the vehicle belt
must be used for installation.
Forward-Facing Installation – LATCH Setup
To Next Page
Loading...
