UPPAbaby Rove - Lap;Shoulder Belt Use

1 2
62
Place Multi-Directional Tether on front side of the
seat prior to installation.
1 Open lock-o door.
2 Ensuring there is no twisting in the belt, route
vehicle lap/shoulder through the lock-o door
and through the RED FORWARD-FACING belt
path. Buckle.
3 While applying pressure into seating surface, as
shown, pull up on the vehicle shoulder belt to
tighten the belt. Holding the shoulder belt taut
to ensure no slack is introduced back into the
vehicle belt, route over the lock-o door
4 Close the bottom section of the
lock-o door over the lap/shoulder belt.
Close the top section of the lock-o door over
the belt. Make sure you push the bottom of
the lock-o door all the way down until you
hear an audible click
4A
.
Note: After closing the lock-o door, the
Tightness Indicator window will turn from
RED TO GREEN
4B
. If it does not, unbuckle
and return to step 2.
Forward-Facing Installation – Lap/Shoulder Belt Use