2-8
Operation
S
TEERING
1. Turn the Drive/Lift Switch to DRIVE.
2. While engaging the Safety Interlock Trigger, push the Steering Switch to RIGHT or LEFT to
turn the wheels in the desired direction. Observe the tires while maneuvering the work
platform to ensure proper direction.
NOTE: Steering is not self-centring. Wheels must be returned to the straight ahead position
by operating the Steering Switch.
E
LEVATING
THE
P
LATFORM
1. Select a firm, level surface.
2. Select LIFT mode.
3. While engaging the Safety Interlock Trigger, push the Joystick forward.
4. If the machine is not level the tilt alarm will sound and the machine will not lift or drive.
5. If the tilt alarm sounds the platform must first be fully lowered, then elevate the platform
approximately 600mm (2ft), stop, press and hold the LEVEL button until the tilt alarm is
silenced. Only then can you elevate fully. If the platform is not levelled correctly the tilt alarm
will continue to sound and lift functions will be cut at a height of approximately 2m (6ft).
T
RAVEL
W
ITH
THE
P
LATFORM
E
LEVATED
NOTE: The machine will travel at reduced speed when the platform is elevated.
1. Check that the route is clear of obstacles (persons, obstructions, holes, drop-offs, bumps,
and debris), is level, and is capable of supporting the wheel loads.
2. Check clearances above, below, and to the sides of platform.
3. Select DRIVE mode.
4. Engage the Safety Interlock Trigger on the Joystick and move to FORWARD or REVERSE to
travel in the desired direction. The speed of the machine will vary depending on how far from
center the Joystick is moved.
5. If the machine is not level the tilt alarm will sound and the machine will not lift or drive. If the
tilt alarm sounds the platform must be lowered and the machine moved to a firm, level
surface before attempting to re-elevate the platform.
L
OWERING
THE
P
LATFORM
1. Select LIFT mode.
2. Check around the base of the platform to ensure that no one is in contact with the machine.
Engage the Safety Interlock Trigger and pull back on the Joystick to lower the platform.
3. The platform will stop when it reaches the PPE cutout height. Inspect around the machine to
ensure no one is in contact with the machine. After a four-second time delay, lower the
platform as in step 2.
L
EVELLING
THE
P
LATFORM
The AUTO LEVEL feature is designed to level the platform in a situation where the ground has no
more than a 13 degree slope side to side and 9 degrees fore and aft, if the slope is greater than 13
degrees side to side and 9 degrees fore and aft the AUTO LEVEL feature will not function.
NOTE: The tilt alarm will continue to sound until the platform is level
To Next Page
Loading...
Need help?
General
