Utax P-4030 - Page 56

2-14
Installing and Setting up the Machine > Default Settings of the Machine
5 Press the [▲] or [▼] key to select [IPv4 Setting], and press the [OK] key.
2
Configure the settings.
When setting the static IP address
1 Press the [▲] or [▼] key to select [DHCP], and press the [OK] key.
2 Press the [▲] or [▼] key to select [Off], and press the [OK] key.
3 Press the [▲] or [▼] key to select [IP Address], and press the [OK] key.
4 Use the numeric keys or press the [▲] or [▼] key to set the IP address.
You can set any value between 000 and 255.
Increase or reduce the figures by pressing the [▲] or [▼] key. Use [◄] or [►] to move the position
being entered, which is shown highlighted.
5 Press the [OK] key.
6 Press the [▲] or [▼] key to select [Subnet Mask], and press the [OK] key.
21
TCP/IP Settings:
TCP/IP
Exit
01
IPv4 Setting
02
IPv6 Setting
03
21
IPv4 Setting:
DHCP
Exit
01
Auto-IP
02
IP Address
03
21
DHCP:
Off
01
On
02
*
21
IPv4 Setting:
IP Address
Exit
03
Auto-IP
02
DHCP
01
IP Address:
0. 0. 0. 0
21
IPv4 Setting:
Auto-IP
Exit
02
Subnet Mask
04
IP Address
03