2NM/2NX/2NY/2NZ/2P0/2P6
1-3-3
Operation
panel and
support
equipment
U201 Init Touch Panel (HyPAS only) It adjusts, when the detection position of
the touch panel has shifted.
U203 Chk DP Ope Each simulation is operated with DP simple
substance.
U207 Chk Panel Key An operation key is checked.
U222 Set IC Card Type Sets the type of IC card.
Mode set-
ting
U250 Mnt Cnt Pre-set The preset value (number of sheets) of a
maintenance cycle is set up.
U251 Clr Mnt Cnt A maintenance counter are displayed and
the data are changed.
U252 Set Dest The destination is set up.
U253 Sel D/S Count The copy count methods (double count),
such as a total counter, are set up.
U260 Set Count Mode The timing (feeding or ejection) which a
total count etc. count is changed.
U265 Set Model Dest The consecutive numbers of the OEM are
set up.
U285 Set Svc Sts Page A coverage report output (permission or
failure) is channged.
U332 Adj Calc Rate The coefficient of the fixed form external
application paper to A4 (or 11x8.5) paper is
set up.
U339 Chk Drum Heater The display existence of a drum heater
setup of a system menu is changed.
U345 Set Mnt Time Disp The number of sheets of a check close dis-
play is set up.
U346 Slct Sleep Mode A BAM conformity country is set up.
Image pro-
cessing
U402 Adjust Margin The space of a leading edge, AC side, and
a trailing edge is adjusted.
U403 Scan Margin Tbl The margin of reading data is adjusted by
picture reading by a scanner.
U404 Scan Margin DP The margin of reading data is adjusted by
picture reading by DP
U411 Auto Adj Scn A scanner and DP are adjusted automati-
cally.
U425 Set Target The target value of an adjustment original
is set up.
Network U520 Set TDRS Perform TDRS settings and information
views.
Section
Item
No.
Content of maintenance item Summary
To Next Page
Loading...
Need help?
General
Weight and Dimensions
