Vacon 100 INDUSTRIAL - Page 37

-XD1
L
-FCE
6 A
1
-EB1.1
-XD4
N
-EB1.2
-EB1.3
-EB1.4
-QAM
-XD4
Fig. 18: The cabinet heater
+CACL: CABINET LIGHT
With this option the control compartment will have a light as default by an internal auxiliary
transformer or as an option by an external auxiliary voltage supply connected to –XD1.1.
The requirements: +CAPU Auxiliary AC supply terminals or +CAPT Auxiliary voltage
transformer
N
L
1
-XD1
-XD1
-FCC
2 A
-EA1
5W
Fig. 19: The cabinet light
+CAPT: AUXILIARY VOLTAGE TRANSFORMER
This option provides the supply of auxiliary voltage for other options. The supply for the
auxiliary transformer is taken from mains. If you use the option AC fuses and fuse switch
(+CIFD), the supply for the auxiliary voltage transformer is taken from between the drive and
the fuse switch. This means that the control voltage is disconnected with the main switch.
The requirements: Not +CAPU Auxiliary AC supply terminals
2
2
4 A
1
I>
3
-TA4
L1-L2
-FC6
-FC4
-XD1
Fig. 20: The auxiliary voltage transformer
MOUNTING VACON · 37
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
4