+CAPU: AUXILIARY AC SUPPLY TERMINALS
This option provides terminals –XD1.1 for an external voltage supply. The external supply
must be short-circuit protected. The power of this supply depends on other selected cabinet
options.
The requirements: Not +CAPT Auxiliary voltage transformer.
WARNING!
The main switch does not disconnect the external voltage supply. Before you touch
the components of the control compartment, disconnect the external voltage
supply. The voltage can be very dangerous.
Fig. 21: The auxiliary AC supply terminals
+CAPD: 24 VDC POWER SUPPLY
This option provides a backup supply for the control unit of the drive. Use it also for other
auxiliary options for which a 24 VDC supply is necessary.
The +24 VDC voltage is supplied to the GND (-XD2:20) and +24 Vin (-XD2:30) terminals.
The requirements: +CAPU Auxiliary AC supply terminals or +CAPT Auxiliary voltage
transformer. The backup supply for the control unit requires +CAPU Auxiliary AC supply
terminals, because for +CAPU, the power is not switched off with the main switch.
L
1
ACAC
N
- +
-XD1
-FC7
2 A
-TB7
24 V
60 W
-XD1
-XD3
Fig. 22: The 24 VDC power supply
+CAPS: AC CUSTOMER SOCKET
The socket provides a power supply for your measurement equipment, tools or computer.
The type of the socket is CEE 7/3 ("Schuko", Type F) or NEMA 5-15 grounded (Type B).
The default voltage is 230 VAC, and 115 VAC in the North American regional variant. The
maximum output power with 230 VAC is 450 VA and with 115 VAC it is 230 VA when an
external supply (+CAPU) is used, and 180 VA when a transformer supply (+CAPT) is used.
The requirements: +CAPU Auxiliary AC supply terminals or +CAPT Auxiliary voltage
transformer
VACON · 38 MOUNTING
4
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
To Next Page
Loading...
