Vacon NX Active Front End User Manual

6
vacon • 76 Control Keypad
Tel. +358 (0) 201 2121 • Fax +358 (0)201 212 205
Figure 54. Keypad navigation chart
6.3.1 Monitoring menu (M1)
You can enter the Monitoring menu from the Main menu by pressing
Menu button right when the
location indication M1 is visible on the first line of the display. Figure 55 shows how to browse
through the monitored values.
The monitored signals carry the indication V#.# and they are listed in Table 25. The values are
updated once every 0.3 seconds.
This menu is meant only for signal checking. The values cannot be altered here. For changing
values of parameters, see Chapter 6.3.2.
FT1

T7
STOP FAULT
I/Oterm
STOP
I/Oterm
FAULT
H1

H3
READY
I/Oterm
T1

T7
I/Oterm
READY
I/ O t er m
READY
S1

S9
STOP READY
I/Oterm
STOP READY
I/Oterm
enter
G1

G5
RE A D Y
I/Oterm
A:NXOPTA1
READY
I/Oterm
G1

G1
READY
I/ O t e r m
V1

V15
READY
I/Oterm
RUN
13.95 Hz
READY
I/Oterm
RUN
G1

G9
READY
I/Oterm
P1

P15
READY
I/Oterm
13.95 Hz
READY
Local
P1

P3
READY
I/Oterm
ST OP
READY
I/Oterm
ST OP
enter
enter
F0
STOP FAULT
I/Oterm
Parameters Basic parameters Min Frequency
1 1 O utput phase Operatio n days
17
Fault his tory 11 Out put phase Operati on days
Sys tem Menu Language
Change
value
Browse
Expander boards
Par ameters
P1

P3
Monitor Output frequency
No editing!
Keypad control
Con tro l Place
I/O Terminal
Change
value
Change
value
Browse
Browse
Active faults
17
English
or:
11205.emf

Vacon NX Active Front End Specifications

General

Brand	Vacon
Model	NX Active Front End
Category	Controller
Language	English